吊り具とスプールの間に隙間が無い様に奥まで挿入すること。
ストッパーは固定金具を外す直前まで取り付けたままにすること
吊り具とスプールの間に隙間が無い様に奥まで挿入すること
隙間が２０㎜以上あると脱落防止の突起に乗り上げてしまうため危険！
スプールが吊り具より外れ落下し足をはさまれ怪我をする。
スプールがコイルスタンドに引っ掛かるため抜けない。
ﾎｲｽﾄｸﾚｰﾝに過剰な負荷をかけてしまう。
ストッパーが無いと固定金具が足の上に落下する恐れがある。
移動中のスプールが人にあたり怪我させてしまう
Rating
52
Translation / English
- Posted at 21 May 2015 at 22:50
Insert it deeply without any space between the hoisting and the spool.
Keep the stopper attached until just before the fitting metal is removed.
Insert it deeply without any space between the hoisting and the spool.
If the space has more than 20mm, it runs upon the projection for preventing it from falling down.
You could be injured by the spool falling from the hoisting and on your foot.
The spool could not be removed because it will be stuck with the coil stand.
The hoist crane could be choke up.
Without the stopper, the fitting metal could fall down on your foot.
The moving spool could hit and injure the worker.
fgxrlpmail64om likes this translation
Keep the stopper attached until just before the fitting metal is removed.
Insert it deeply without any space between the hoisting and the spool.
If the space has more than 20mm, it runs upon the projection for preventing it from falling down.
You could be injured by the spool falling from the hoisting and on your foot.
The spool could not be removed because it will be stuck with the coil stand.
The hoist crane could be choke up.
Without the stopper, the fitting metal could fall down on your foot.
The moving spool could hit and injure the worker.
Rating
52
Translation / English
- Posted at 21 May 2015 at 23:00
Insert it gaplessly between the hanger and the spool to a depth.
Keep the stopper attached til just before removing the fixed metal fittings.
Insert it gaplessly between the hanger and the spool to a depth.
It is dangerous to have the gap of more than 20mm, where it may run onto a preventive projection for falling off!
The spool may come off the hanger and drop, and it may be caused that a foot is clipped and injured.
Because the spool is caught on a coil stand, it cannot pull out.
May place too much a load on the hoist crane.
If there is no stopper, fixed metal fittings might drop on a foot.
Moving spool may hit and injure persons.
fgxrlpmail64om likes this translation
Keep the stopper attached til just before removing the fixed metal fittings.
Insert it gaplessly between the hanger and the spool to a depth.
It is dangerous to have the gap of more than 20mm, where it may run onto a preventive projection for falling off!
The spool may come off the hanger and drop, and it may be caused that a foot is clipped and injured.
Because the spool is caught on a coil stand, it cannot pull out.
May place too much a load on the hoist crane.
If there is no stopper, fixed metal fittings might drop on a foot.
Moving spool may hit and injure persons.
Rating
50
Translation / English
- Posted at 21 May 2015 at 20:46
Insert sling all the way until there is no gap between spool.
Stoppers should remain attached just right before you remove the fixing bracket.
Insert sling all the way until there is no gap between spool.
It is dangerous that it will run on to the projection of the dropout prevention if the gap is more than 20 mm.
When spool falls off from the sling, your legs will get injured.
Spool won’t come out if it will be caught in the coil stand.
It would put an excessive load on the hoist crane.
There is a risk of a fixing bracket falling on your feet if there is no stopper.
When moving spool from one place to another, it may hurt people around it.
fgxrlpmail64om likes this translation
Stoppers should remain attached just right before you remove the fixing bracket.
Insert sling all the way until there is no gap between spool.
It is dangerous that it will run on to the projection of the dropout prevention if the gap is more than 20 mm.
When spool falls off from the sling, your legs will get injured.
Spool won’t come out if it will be caught in the coil stand.
It would put an excessive load on the hoist crane.
There is a risk of a fixing bracket falling on your feet if there is no stopper.
When moving spool from one place to another, it may hurt people around it.
