処置方法
曲がりチェック！
計測器点検方法
基準サンプルパイプは材質毎、外径寸法毎に１本ずつ用意する｡
基準サンプルにはテプラー等で材質を明示する｡
使用時に基準サンプルパイプの点検を行う
爪で引っ掛かる有害な傷、外径変形等は、基準サンプルパイプを交換(再製作)する｡
プローブ(接触端子)を前面パネル⑧PROBEコネクターに接続する｡
測定するパイプ径に合わせてパイプ切換えスイッチを切換える｡
バッテリー切替えスイッチをBATT側にセットする｡
通常電源は内蔵バッテリーを使用する
Rating
50
Translation / English
- Posted at 25 May 2015 at 14:43
Procedure
Warp inspection required!
How to inspect a measuring instrument
Prepare a standard sample pipe per material/external diameter.
Specifically label its material on the standard sample; use labeling device such as 'Tepra'.
Inspect the standard sample pipe before use.
Change (or reproduce) the standard sample pipe in case troubled scratches caught by fingernails or a deformation was found on the surface.
Connect the probe (contact terminal) to the PROBE Connector placed on the front panel ⑧.
Throw the pipe conversion switch according to the pipe diameter.
Turn the battery conversion switch to the BATT side.
A built-in battery is generally used for the power source.
maikurepa likes this translation
Warp inspection required!
How to inspect a measuring instrument
Prepare a standard sample pipe per material/external diameter.
Specifically label its material on the standard sample; use labeling device such as 'Tepra'.
Inspect the standard sample pipe before use.
Change (or reproduce) the standard sample pipe in case troubled scratches caught by fingernails or a deformation was found on the surface.
Connect the probe (contact terminal) to the PROBE Connector placed on the front panel ⑧.
Throw the pipe conversion switch according to the pipe diameter.
Turn the battery conversion switch to the BATT side.
A built-in battery is generally used for the power source.
Rating
52
Translation / English
- Posted at 25 May 2015 at 14:52
Treatment Method
Check for bends!
Inspection method of measuring instruments
Use one standard sample pipe for each material and each outer diameter.
Label each standard sample with its material, with a labeler such as Tapler.
Inspect the standard sample pipe before each use.
When ledges detectable with fingernails or outer diameter circumference deformity is detected, replace (remanufacture) the standard sample pipe.
Connect the probe (connector probe) to the front panel ⑧ probe connector.
Change pipe switch switch depending on the diameter of the pipe to be measured.
Set battery switch to BATT side.
Use interior battery for normal power source.
Check for bends!
Inspection method of measuring instruments
Use one standard sample pipe for each material and each outer diameter.
Label each standard sample with its material, with a labeler such as Tapler.
Inspect the standard sample pipe before each use.
When ledges detectable with fingernails or outer diameter circumference deformity is detected, replace (remanufacture) the standard sample pipe.
Connect the probe (connector probe) to the front panel ⑧ probe connector.
Change pipe switch switch depending on the diameter of the pipe to be measured.
Set battery switch to BATT side.
Use interior battery for normal power source.
