サンプルの採取のタイミングですが、何Kg流したところから採取すればよいでしょうか？
Aについては、材質・線径・線の形状・密度・層の組み合わせが我々のノウハウになります。それをライセンサーと一緒に決めて、承認をもらっておりますので、ローカルメーカーには恐らく作ることはできないと思います。
前回打合せた通り、Bでは圧力に耐えられないので、Cにて提案しています。
評価
55
ネイティブ
翻訳 / 英語
- 2017/11/24 11:16:11に投稿されました
About the timing of taking samples, which point with how many kilograms flowing would be good to take samples?
With regard to A, material quality, wire diameter, wire shape, density, layer combination will be our know-how. We have decided on that together with the licenser and received approval so I think local manufacturers probably can't make them.
As was discussed in the previous meeting, B can't withstand the pressure so doing it with C was proposed.
With regard to A, material quality, wire diameter, wire shape, density, layer combination will be our know-how. We have decided on that together with the licenser and received approval so I think local manufacturers probably can't make them.
As was discussed in the previous meeting, B can't withstand the pressure so doing it with C was proposed.
評価
50
翻訳 / 英語
- 2017/11/24 11:13:05に投稿されました
As for sample taking timing, from how many kilograms flow can I take?
As for A, material/wire diameter/wire shape/density and layer combination are our know-how. As we are approved these together with a licensor, a local maker might not be able to make it.
As we have discussed before, as B cannot sustain the pressure, we are suggesting with C.
As for A, material/wire diameter/wire shape/density and layer combination are our know-how. As we are approved these together with a licensor, a local maker might not be able to make it.
As we have discussed before, as B cannot sustain the pressure, we are suggesting with C.
評価
52
翻訳 / 英語
- 2017/11/24 11:21:26に投稿されました
As for the timing of sampling, how many Kg is flowed should we start to sample?
As for A, the combination of the shaping of material/meridian/line will be our know-how. Since we decide it with the licenser together and obtains the approval, it may impossible for the local manufacturers to create it.
According to the previous meeting, C is suggested since B cannot endure pressure.
As for A, the combination of the shaping of material/meridian/line will be our know-how. Since we decide it with the licenser together and obtains the approval, it may impossible for the local manufacturers to create it.
According to the previous meeting, C is suggested since B cannot endure pressure.
