切断初品最終品はｺﾝﾍﾞｯｸｽで寸法測定をし確認する
リングゲージで外径をチェックする
パイプを手に持ち、キズをチェックする
キズは限度見本参照の事
サイクル運転後必ず初品チェックをする
切断公差
600㎜未満：±1.0
600㎜以上：±2.0
不良品が流出する
マーク材塗料が発見出来ない
工程内不良の把握が出来ず対策が出来ない
手をはさみ、災害となる
１サイクルで止まってしまう
異品が混入する恐れがある
パイプ径不良が流出する
測定ミス、パイプキズが発生する
日常保全チェックシート
Rating
52
Translation / English
- Posted at 21 May 2015 at 12:20
Confirm the first and last articles of cutting by dimensional measurement with the convex.
Check outer diameter by a ring gage.
Hold the pipe in a hand, and check scratches.
Refer to the limit samples as to the scratches.
Check the first article after cycle driving by all means.
Cut clearance
600mm and less : +-1.0
600mm and more: +-2.0
Defective articles flow out.
Cannot find the mark materials paint.
Cannot take measures without being able to grasp the defectiveness in the process.
Have a hand caught resulting in a disaster.
Stops at 1 cycle.
Foreign articles might get mixed.
Pipe diameter defectives flow out.
Measurement errors and pipe scratches wound occur.
Daily maintenance check sheet
signandwaai likes this translation
Check outer diameter by a ring gage.
Hold the pipe in a hand, and check scratches.
Refer to the limit samples as to the scratches.
Check the first article after cycle driving by all means.
Cut clearance
600mm and less : +-1.0
600mm and more: +-2.0
Defective articles flow out.
Cannot find the mark materials paint.
Cannot take measures without being able to grasp the defectiveness in the process.
Have a hand caught resulting in a disaster.
Stops at 1 cycle.
Foreign articles might get mixed.
Pipe diameter defectives flow out.
Measurement errors and pipe scratches wound occur.
Daily maintenance check sheet
Rating
52
Translation / English
- Posted at 21 May 2015 at 12:44
Initial and last cut pieces will be measured by a convex ruler to verify dimensions.
Outer diameter is verified with a ring gauge.
Handhold pipes to check for scratches.
Refer to scratch tolerance sample.
It is essential to inspect the first cut after cycle operation starts.
Cut tolerance
less than 600mm : ±1.0
greater than (and including) 600mm: ±2.0
Defective products get into circulation
Unable to find marking paint
Unable to find solutions without a good grasp on defective products within processes
A hand trapped in machinery, an accidents results
Stops after the first cycle
Possibility of foreign object contamination
Pipes with inaccurate diameters get into circulation
Measuring error, occurrence of scratched pipes
Daily safety checklist
Outer diameter is verified with a ring gauge.
Handhold pipes to check for scratches.
Refer to scratch tolerance sample.
It is essential to inspect the first cut after cycle operation starts.
Cut tolerance
less than 600mm : ±1.0
greater than (and including) 600mm: ±2.0
Defective products get into circulation
Unable to find marking paint
Unable to find solutions without a good grasp on defective products within processes
A hand trapped in machinery, an accidents results
Stops after the first cycle
Possibility of foreign object contamination
Pipes with inaccurate diameters get into circulation
Measuring error, occurrence of scratched pipes
Daily safety checklist
翻訳していただき、本当にありがとうございました。