４月２６日にこちらのサイトで望遠鏡を購入しました。
本日動作確認をしたのですが、ダブルスタック・モジュールを外してシングルで見ると画面全体が赤くハレーションを起こした状態でした。プロミネンスは良く見えるのですが、表面の模様が大変薄く確認し難い感じでした。赤カブリがすごい状態なので何処かに不具合があるのではと思われます。ハレーションを完全に視野外に追い出すことが出来ません。
何か対処方法はありますでしょうか？
評価
50
翻訳 / 英語
- 2012/05/19 01:10:57に投稿されました
I have purchased telescope from your website.
When I checked the function today, red halation occurred in entire display with single, removing double stuck module. I can see prominence well, but the surface patter was very vague and hard to distinguish. I am assuming that it could be some sort of defect since red fog is way too much. I cannot eliminate the halation completely out of sight. Do you have any suggestion?
When I checked the function today, red halation occurred in entire display with single, removing double stuck module. I can see prominence well, but the surface patter was very vague and hard to distinguish. I am assuming that it could be some sort of defect since red fog is way too much. I cannot eliminate the halation completely out of sight. Do you have any suggestion?
評価
68
ネイティブ
翻訳 / 英語
- 2012/05/18 23:41:02に投稿されました
I bought a telescope on this site on April 26th.
I checked its operations today but when I took off the double stack module and looked through the single there was a red halo-effect around the entire screen. I can see the solar prominence well, but I very weakly checked the surface pattern and it felt hard. The red fog was so strong I think there must be a defect somewhere. I cannot expel the halo-effect completely from my field of vision.
Do you have any solutions to this?
I checked its operations today but when I took off the double stack module and looked through the single there was a red halo-effect around the entire screen. I can see the solar prominence well, but I very weakly checked the surface pattern and it felt hard. The red fog was so strong I think there must be a defect somewhere. I cannot expel the halo-effect completely from my field of vision.
Do you have any solutions to this?
★★☆☆☆ 2.0/1
評価
50
翻訳 / 英語
- 2012/05/19 11:01:29に投稿されました
I bought a telescope at your site on Apr 26. And I checked out today.
I could confirm after I took out a double stack module from it and looked at the sun just through a telescope. But, it caused red halation on a whole image.
I could see a prominence clearly, but it's difficult to see the sun's surface, becauce the pattern of the surfice is too weak.
And there's much red tint. So, I think there is something wrong with it.
I couldn't expel halation completely.
Is there a way of dealing with it?
I could confirm after I took out a double stack module from it and looked at the sun just through a telescope. But, it caused red halation on a whole image.
I could see a prominence clearly, but it's difficult to see the sun's surface, becauce the pattern of the surfice is too weak.
And there's much red tint. So, I think there is something wrong with it.
I couldn't expel halation completely.
Is there a way of dealing with it?
