組んでいる部分の接着剤が剥がれ、(特に四隅とセンター）画像のような状態になっている物が多く出てしまっています。接着剤の量を増やすとともに四隅の部分はビスを打ち込み、尚且つビスを打ち込んだのを目立たせなくして頂きたいです。また下の画像にあります穴が多く空いています穴があれば埋めて頂くようお願い致します。
評価
44
翻訳 / 英語
- 2017/09/21 12:38:39に投稿されました
The adhesive in in the attached part is peeling off and the part comes out (especially in four corners and the center part), so many of the products look like as the picture shows. Please increase the amount of the adhesive and put screws into the four corners and hide them so that they are not visible from outside. Also as the picture below shows, there are a lot of holes in the product. If there remain holes, please make sure to fill them.
評価
50
翻訳 / 英語
- 2017/09/21 12:43:31に投稿されました
The adhesive at where it is included is removed and many are like the image (remarkably 4 corners and center). I want you to increase amount of the adhesive while hitting screw at the 4 corners as well as make the hit screw invisible. As it shown in the image listed below, there are many holes. Please fill the hole if the holes are not filled.
評価
50
翻訳 / 英語
- 2017/09/21 12:46:35に投稿されました
The glue at linked parts has come off (especially the corners and the center) and many of them are such as shown in the picture attached. Could you please use more glue and also screw all four corners in, as well as making the screws as invisible as possible. As you see in the picture below there seem to be quite a few holes. If you spot them could you please fill them up .
評価
50
翻訳 / 英語
- 2017/09/21 12:47:10に投稿されました
The adhesive on the part of where it is gathered is coming off, and you can see some (especially in the four corners and center) as attached image. Please kindly increase the amount of the adhesive and hit a screw in the four corners, together with being hard to spot of the screws. In addition, if you find any holes like the image, please fill it.
評価
50
翻訳 / 英語
- 2017/09/21 12:46:09に投稿されました
Peeling of the adhesive in the part where it is gathered, many things that are like the image (especially at the four corners and the center) have come out. I would like you to increase the amount of adhesive and drive the screws at the four corners, and furthermore do not distinguish the driving of the screws. Moreover, there are many holes in the image below, so please fill in if there is a hole.
