何度か箔押しを試してみたのですが、レバーで降ろすヒーター台に若干の傾きがあるようで、硬い素材に箔を押す場合にステージ奥側しか箔が押されないようになっています。
現状では、箔押しされる素材を少し傾けるように下に紙を挟んで対応しておりますが、うまく安定した箔が押せません。
何かヒーター台かステージの傾きを調整する方法がございましたらお教えください。
Rating
57
Translation / English
- Posted at 28 May 2012 at 16:47
I tried several times to push the foil, but there seem to be some degrees of leaning in the heater stand when take down with a lever, and, when I push the foil onto firm material, only the depths sides of stage can be pushed.
The present situation is that, the paper below was able to be sandwiched if the material performed incline a little, but stable foil cannot be pushed.
If there is a method to adjust the degree of leaning of heater stand or the stage, please tell me.
The present situation is that, the paper below was able to be sandwiched if the material performed incline a little, but stable foil cannot be pushed.
If there is a method to adjust the degree of leaning of heater stand or the stage, please tell me.
Rating
57
Translation / English
- Posted at 28 May 2012 at 14:25
I have tried to push the foil but it seems there is some inclination of the heater unit which you lever down.Thus it only pushes the foil to the stage side when pushing foil onto relatively hard material.
At this moment, we are inclining the foil to the downer direction by folding a paper underneath it but it is creating some problem of not being able to stample properly.
Please kindly advise if there is any method to adjust the stage or inlination of the heater unit.
At this moment, we are inclining the foil to the downer direction by folding a paper underneath it but it is creating some problem of not being able to stample properly.
Please kindly advise if there is any method to adjust the stage or inlination of the heater unit.
