ワーク毎にアライメント(位置補正)
イントレー検査が可能
リードエッジ検出により位置検出
水平方向のリード曲がりも測定可能
面測定を行うことで、ワーク全体の形状の把握が可能
2次元寸法検査も同時に可能
面測定により形状の把握
接点の再頂点を自動算出が可能(レーザーやプローブによる測定は不可能)
面測定により、接点コブラナリティと基盤との接点のリード
コプラナリティを同時に検査可能
検査行程の軽減につながります
非接触3次元検査装置
基板のソリ検査、個片パターンのコプラナリティ検査
Translation / English
- Posted at 11 Dec 2013 at 14:00
Alignment for every work (Position correction)
In-tray inspection is possible
Position detected by the lead edge detection
Horizontal direction lead bending is also measurable
By performing a surface measurement, it is possible to understand the shape of the entire work
A two-dimensional measurement inspection is also possible at the same time
Understand the shape with surface measurement
It is possible to automatically calculate for the re-peaking of the tangent point (It is not possible to measure with lasers and probes)
The contact co-planarity and the contact lead with the base by surface measurement
It is possible to inspect the co-planarity at the same time
This leads to the reduction of the inspection process
Three-dimensional non-contact inspection equipment
Sled inspection of board, co-planarity inspection of individual pieces
In-tray inspection is possible
Position detected by the lead edge detection
Horizontal direction lead bending is also measurable
By performing a surface measurement, it is possible to understand the shape of the entire work
A two-dimensional measurement inspection is also possible at the same time
Understand the shape with surface measurement
It is possible to automatically calculate for the re-peaking of the tangent point (It is not possible to measure with lasers and probes)
The contact co-planarity and the contact lead with the base by surface measurement
It is possible to inspect the co-planarity at the same time
This leads to the reduction of the inspection process
Three-dimensional non-contact inspection equipment
Sled inspection of board, co-planarity inspection of individual pieces
Translation / English
- Posted at 11 Dec 2013 at 13:36
To work for each alignment (position correction)
Can be Intore check
Position detected by the lead edge detection
Also, It can measure about lead bending in the horizontal direction
By performing a surface measuring, can grasp the shape of the entire work
Can be 2D dimensional inspection at the same time
understanding shape by a surface measuring
Can be automatically calculate about the re-vertex contact
(Measured by the probe or laser is impossible)
By a surface measuring, lead point of contact with the base and contact coplanarity
Can be tested the coplanarity at the same time
It leads to the reduction of checking process
Three-dimensional non-contact inspection equipment
Testing about sled of the board,
Testing about coplanarity of pattern pieces
Can be Intore check
Position detected by the lead edge detection
Also, It can measure about lead bending in the horizontal direction
By performing a surface measuring, can grasp the shape of the entire work
Can be 2D dimensional inspection at the same time
understanding shape by a surface measuring
Can be automatically calculate about the re-vertex contact
(Measured by the probe or laser is impossible)
By a surface measuring, lead point of contact with the base and contact coplanarity
Can be tested the coplanarity at the same time
It leads to the reduction of checking process
Three-dimensional non-contact inspection equipment
Testing about sled of the board,
Testing about coplanarity of pattern pieces