エンジニアより確認依頼がありますので、下記の件ご確認をお願い致します。
1. 仕様書の中のOperating caseですが、4Case記載があります。
1つの製品で4Caseに対応させるのでしょうか？
一般的にPolymerは滞留劣化を嫌うので、 3倍近い流量差での設計は滞留が多くなります。
2. 4way Valveで3台容器を並列に接続して使用するのでしょうか？
かなり特殊な構造かと思いますが、今回はパイロットプラントでしょうか？
評価
50
翻訳 / 英語
- 2021/07/13 19:02:10に投稿されました
Please check the following cases, as I was asked to be checked by the engineer.
1.As for Operating case in the specification, there is 4 Case is written.
Could it be possible to do with one product for 4 Cases?
Generally, as polymer does not like accumulation aging, the flow difference of three times plan will make accumulation aging much.
2. With 3 way valve, is it used continuously by alining 3 bases?
I think it would be a quite special function, is this time's one is a pilot plant?
1.As for Operating case in the specification, there is 4 Case is written.
Could it be possible to do with one product for 4 Cases?
Generally, as polymer does not like accumulation aging, the flow difference of three times plan will make accumulation aging much.
2. With 3 way valve, is it used continuously by alining 3 bases?
I think it would be a quite special function, is this time's one is a pilot plant?
![[削除済みユーザ]](https://secure.gravatar.com/avatar/695023b4efd563721d13716b1457bc73.png?d=identicon&mode=crop&r=PG&s=42)
評価
52
翻訳 / 英語
- 2021/07/13 19:06:37に投稿されました
As there are requests for confirmation from the engineer, please make sure of the following.
1 As for the operation case in the specification, there are 4 cases in the description.
Do you mean to correspond the 4 cases by 1 product?
Generally, polymers dislike deterioration for stagnation, it will be increased for designing on the difference of flow of up to 3 times.
2 Do you use 3 containers with a 4-way valve with a parallel connection?
Although the structure is very specific, is it a pilot plant at this time?
1 As for the operation case in the specification, there are 4 cases in the description.
Do you mean to correspond the 4 cases by 1 product?
Generally, polymers dislike deterioration for stagnation, it will be increased for designing on the difference of flow of up to 3 times.
2 Do you use 3 containers with a 4-way valve with a parallel connection?
Although the structure is very specific, is it a pilot plant at this time?
