作業手順及び作業上のポイント
作業上注意
注意を守らないとこうなる
切断寸法の設定
現品票に基き､サイズ、材質を確認し入力設定をする
送りセットを切断長通りに入力する
切断本数の設定
現品票に基き、切断本数を確認する
切断本数を入力後日報に記入する
切断の開始
切断寸法・本数設定の再確認をする
マーク材、工程内不良が出た時に切断本数が少なくなってしまう
切り込みキズが入ったまま流出する恐れがある
切断加工油はサンプレス油使用
ｵｲﾙﾀﾝｸ内に１／２以上有ることを確認する
１回／1直確認
曲がりを確認する
評価
57
翻訳 / 英語
- 2015/05/20 17:19:07に投稿されました
Work procedures and points of the work
Notice of work
If you don't follow the notice, it will become like this
Setting of cutting dimension
Based on the identification tag, check the size and material and do the input setting
Enter the feed set with the cutting length
Setting of cutting number
Based on the identification tag, confirm the cutting number
Enter the cutting number and fill in the daily report
Start cutting
Re-confirmation of the cutting size and the number setting
The cutting number will be less when there are mark materials and process failures.
The product might escape with a cutting line on it
Use Sun press oil as cutting process oil
Confirm that there is more than half in the oil tank
Once / 1 direct confirmation
Check the bend
monakadaikiraiさんはこの翻訳を気に入りました
Notice of work
If you don't follow the notice, it will become like this
Setting of cutting dimension
Based on the identification tag, check the size and material and do the input setting
Enter the feed set with the cutting length
Setting of cutting number
Based on the identification tag, confirm the cutting number
Enter the cutting number and fill in the daily report
Start cutting
Re-confirmation of the cutting size and the number setting
The cutting number will be less when there are mark materials and process failures.
The product might escape with a cutting line on it
Use Sun press oil as cutting process oil
Confirm that there is more than half in the oil tank
Once / 1 direct confirmation
Check the bend
評価
52
翻訳 / 英語
- 2015/05/20 17:41:35に投稿されました
the sequence of work and points during work
precautions during work
When you don't follow important points, it cause like this.
setting for cutting size
check how many we cut based on article slips
input the set for shipping following the cut length
activating to cut
reconfirm cutting size and the set number
When we have defection of mark materials and during process, number of cutting gets less.
We run the risk of flowing out with cuts.
precautions during work
When you don't follow important points, it cause like this.
setting for cutting size
check how many we cut based on article slips
input the set for shipping following the cut length
activating to cut
reconfirm cutting size and the set number
When we have defection of mark materials and during process, number of cutting gets less.
We run the risk of flowing out with cuts.
９行目に
fill out daily report after input the number of cutting を、
最後に
We use sunpress oil for cut working oil.
check that oil is more than half of the oil tank.
once / one direct check
check bending
を追加してください。確認が不十分で本当に申し訳ございません。