Translation Results Requested Through Conyac Made Public

The vehicle is ready for painting

The paint used is a two coats paint (one coat of base coat, one coat of clear coat)

In reality, 2 to 3 coats of base coat and 2 to 3 coats of clear coat are required

Dilute the base coat to 70%

For 300 ml of base coat, add 300 * 0.7 = 210 ml of thinner

Spray the paint begining with the surfaces covered by the primer

Do not turn the wrist: grip the gun keeping perpendicular with the spraying area

Release the trigger at the ends of the trajectories to avoid applying too much paint at the ends

Then apply 2 to 3 coats of base coat over the entire body

Just wait for the base coat to dry to the touch to apply the next coat

The base coat dries quickly: about 10 minutes between coats The clear coat used is a two-component clear coat (clear coat + hardener)

2:1 ratio + 10% thinner

Spray the clear coat to the whole vehicle

Do not apply too thick layers to avoid sagging

Move the gun regularly without lingering over an area to avoid sagging

On the curves, round the trajectory keeping a distance of 20 to 30 cm from the body

If you make a sag, it is possible to erase it after drying the varnish (after 12 hours)

To clear a stain of clear coat, the clear coat should be wetted and the sanding should be done by hand with 320 grit sandpaper followed by 600 (always wet)

It is then sufficient to spray clear coat to the sanded area and the sagging will have disappeared.

Here is the final rendering