原文 / 日本語
コピー
今回製作した曲げ用の治具は、半径Ｒ=１．０の軸でした。
これで曲げ加工を行ったところ、結果は30°程度の曲げクセしか付ける
ことができませんでした。写真１
一方、後からの確認結果ですが、半径Ｒ=０．３の軸を使えば、
60°程度までの曲げクセを付けることが可能であることが、わかりました。写真２
次回の加工では軸の半径をＲ=０．３として治具を改造し、60°以上を狙います。
評価
50
翻訳 / 英語
- 2011/12/22 20:09:09に投稿されました
The bending jig which we produced this time has a shaft radius of 1.0.
The trial with this has proven that this jig can make bend of only about 30 degrees (Photo#1).
After this trial, we found that a jig with a shaft radius of 0.3 can make bend of up to 60 degrees or so (Photo#2).
Next time, we will convert the current jig into the one with a shaft radius of 0.3. In this way we aim to make bend of 60 degrees or more.
The trial with this has proven that this jig can make bend of only about 30 degrees (Photo#1).
After this trial, we found that a jig with a shaft radius of 0.3 can make bend of up to 60 degrees or so (Photo#2).
Next time, we will convert the current jig into the one with a shaft radius of 0.3. In this way we aim to make bend of 60 degrees or more.
評価
44
翻訳 / 英語
- 2011/12/23 03:37:04に投稿されました
The bending jig for this production had the axis of the radius R = 1.0.
With this radius the bending was performed, the results was that it could not bend with only peculiarity about 30 °. Photo 1
Meanwhile, after confirmation from the result, using the axis of the radius R = 0.3,
I came to know that it is possible to form a habit of bending up to about 60 °.Photo 2
In the next process it is to modify the fixture with radius of the axis R = 0.3, aiming for more than 60 °.
With this radius the bending was performed, the results was that it could not bend with only peculiarity about 30 °. Photo 1
Meanwhile, after confirmation from the result, using the axis of the radius R = 0.3,
I came to know that it is possible to form a habit of bending up to about 60 °.Photo 2
In the next process it is to modify the fixture with radius of the axis R = 0.3, aiming for more than 60 °.
主語は複数のweとしましたが、必要に応じてIに変えて頂くようお願い致します。